USB Device Port 5. Print page 1 Print document 43 pages. Turn the handle to open. Setup and Use Figure 3 1. In no event shall POSTEK be liable for any direct or indirect loss, including but not limited to loss of business profits, business interruption, loss of business information, or other pecuniary loss. Connecting The Printer 1 Do not use the printer near liquids or corrosive chemicals. Observe proper electrostatic safety precautions when handling.
|Date Added:||25 May 2010|
|File Size:||65.26 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Postek G-2108 User Manual
See an authorized Postek Reseller for additional information for cutter module. Page 3 see FCC Notice. Interface Specifications — Baud rate: Make sure there is adequate space around pstek printer for loading consumables and proper ventilation.
User can select the appropriate mode of drivre sensor to adapt different media type and reduce error of label skipping or offsetting.
The roller can accumulate debris from consumables, such as dirt, sand, dust or glue. Setup and Use Chapter 2: Setup and Use Figure Postek assumes no liability for any damage in such cases. The printed label count and printed length may not be reset. Clean the Printhead after every 1 roll of ribbon use or every 3 rolls of label media use.
Connecting The Printer 1 Do not use the printer near liquids or corrosive chemicals. To clean the Printhead: Troubleshooting Install the Media Roll Guides correctly and postej them firmly press the positioned against the Media or have media. Observe proper electrostatic safety precautions when handling.
The power rating for the printer is 24VDC. Ensure the correct driver is chosen in the label software.
Standard mode, Peel-off mode, or Cutting mode. Possible Cause Recommend Solutions Ribbon ran out Ribbon Adjusting Wheel 4.
POSTEK G Printer Drivers | BarTender by Seagull Scientific
Direction Definition Ground Connection with host: RS Serial Port 4. The default mode of media sensor is Reflective, but user can change the mode by following these steps: TPH Release Lever Centronics Parallel Port Optional 3. Media loading area 3. Setup and Use Figure 4 1. Clean y-2108 Platen Roller after every 3 rolls of label media used.
Print page 1 Print document 43 pages. Troubleshooting, for error indicators.
Operating the printer in Cutting mode requires the optional Cutter. Lift the top cover.
Setup and Use Loading the Ribbon Warnings: Setup and Use Figure 3 1. Reflective Sensor Ribbon Supply Spindle 2.
Reflective sensor and Transmissive sensor. To ensure longevity of the Platen Roller, follow the recommended maintenance guidelines below: